Wednesday 17 November 2010

Bonnet Locks

I had previously spent ages marking out exactly where the locks go in the bonnet and it was now time to install them, the holes isnt round so takes a wee bit of filing but an easy enough job. The most important thing about this job is to do it before the boday goes on the car as you need to get into the engine bay area to mark the bulkhead where the catch goes into. Mr Dremel out once again :)
I also got all the nuts and bolts tightened up on the bonnet scoop, just need to paint inside it now, should of actually done it before fitting. I need some stainless mesh as well for the front opening on the scoop.



No comments:

Post a Comment